Aiwa CDC-X917M Bedienungsanleitung PDF herunterladen (Seite 21)

– 21 –

Pin No. Pin Name I/O Description

42 CDS SLEEP O SLEEP signal output.

43 CDS STOP I STOP signal input.

44 CDS IN I DISC insertion detect input.

45 SEN2 I Load sens detect input.

46 BBE-2 I BBE input 1. (Not used)

47 BBE-1 I BBE input 2. (Not used)

48 MF.CON O SLEEP signal control output.

49 MI–1 I Diode matrix input for default setting.

50 MI–2 I Diode matrix input for default setting.

51 MI–3 I Diode matrix input for default setting.

52 MO–1 O Diode matrix output for default setting.

53 MO–2 O Diode matrix output for default setting.

54 MO–3 O Diode matrix output for default setting.

55 MO–4 O Diode matrix output for default setting.

56 PANCON1 O Panel control motor reverse drive output.

57 PANCON2 O Panel control motor forward drive output.

58 ACC IN I ON/OFF input for ACC (accessory power supply).

59 BEEP O BEEP output.

60 REMOTE I Remote control input.

61 E–VOL CE O CE output to electrical volume.

62 E–VOL DO O Data output to electrical volume.

63 E–VOL CLO O Clock output to electrical volume.

64 DRV CONT O Hi output during DRIVE mode.

65 RDS DI I RDS data input. (Connected to GND through a resistor)

66 DFP IN I Front panel detection.

67 FLAP IN I OPEN/CLOSE detection of FLAP DFP. DFP IN: Enable when High.

68 RDS CLI I RDS clock input. (Connected to GND through a resistor)

69 JACK IN I JACK detect input.

70 BATT IN I ON/OFF input for BATT.

71 RE-1 I Rotary encoder input 1. (Connected to GND through a resistor)

72 RE-2 I Rotary encoder input 2. (Connected to GND through a resistor)

73 S-REQ – S-REQ signal input for CDS.

74 REG CPU – CPU power-supply regulator.

75 GND – Ground.

76 X–OUT – System clock oscillator.

77 X–IN – System clock oscillator.

78 REG OSC – Oscillator circuit regulator.

79 VDD – System power supply.

80 RESET I System reset.

http://www.xiaoyu163.com

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 37 38

Keine Kommentare

Aiwa CDC-X917M Bedienungsanleitung Seite 21