Aiwa XR-M1000 Bedienungsanleitung PDF herunterladen (Seite 32)

100

If the unit fails to perform as described in these Operating

Instructions, check the following guide.

GENERAL

There is no sound.

• Is the AC cord connected properly?

• Is there a bad connection? (-» page 4)

• There may be a short circuit in the speaker terminals.

»-» Disconnect the AC cord, then correct the speaker

connections.

• Was an incorrect function button pressed?

Sound is emitted from one speaker only.

• Is the other speaker disconnected?

The output sound is not stereo.

• Is the Karaoke function turned on? (-► page 19)

An erroneous display or a malfunction occurs.

-* Reset the unit. See “To reset”.

STEREO RECEIVER

There is constant, wave-like static.

• Is the antenna connected properly? (-* page 5)

• Is the signal weak?

-► Connect an outdoor antenna.

The reception contains noise interferences or the sound

is distorted.

• Is the system picking up external noise or multipath distortion?

-> Change the orientation of the antenna.

-+ Move the unit away from ofher electrical appliances.

CASSETTE DECK

The tape does not run.

• Is deck in pause mode? (-» page 25)

The sound is off-balance or not adequately high.

• Is the playback head dirty? (-> page 31)

Recording is not possible.

• Is the erasure prevention tab on the tape broken off? {-* page

26)

• Is the recording head dirty? (-♦ page 31)

Erasure is not possible.

• Is the erasure head dirty? (-» page 31)

• Is a metal tape being used?

High frequency sound is not emitted.

• Is the recording/playback head dirty? (-> page 31)

• Is a tape recorded without Dolby NR played back with the Dolby

NR system operating? (-» page 25)

CD PLAYER

The CD player does not play.

• Is the disc correctly placed? (-> page 20)

• Is the disc dirty? (-► page 31)

• Is the lens affected by condensation?

-* Wait approximately one hour and try again.

To reset

If an unusual condition occurs in the display windows or the

cassette decks, reset the unit as follows.

1 Press POWER to turn off the power.

2 Press POWER to turn the power back on while pressing

SET. Everything stored in memory after purchase is

canceled.

If the power cannot be turned off in step 1 because of a

malfunction, disconnect the AC cord. Then connect it again

and carry out step 2.

POWER

32 ENGLISH

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 99 100

Kommentare zu diesen Handbüchern

Keine Kommentare

Aiwa XR-M1000 Bedienungsanleitung Seite 32

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Akustik Aiwa XR-M1000